MuxLab 500470 Installation Guide download pdf (Page 18)

Page 18

3.8. Cloning EDID

In order to clone the EDID of a display, follow the procedure listed below with the

cloning kit included with each Multimedia 16x16 Matrix Switch:

1. Power up the EDID Emulator/Learner with the adaptor provided.

2. Plug the DVI to HDMI adaptor to the DVI output of the EDID Emulator/Learner.

3. Plug the HDMI connector to the display device that you wish to clone.

4. Verify that the EDID WR switch is set to “Unlock”.

5. Press the “Read” pushbutton. The “Read” LED should illuminate for

approximately 2 seconds.

6. Plug the HDMI connector to the input HDMI port where you want the new EDID

applied.

7. Press the “Write” pushbutton. The “Write” LED should illuminate for

approximately 2 seconds.

NOTE: If both LEDs illuminate after performing an operation, this indicates that

the operation has failed. Perform the operation again, making sure that the display

device you are attempting to clone is powered up.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

No comments

MuxLab 500470 Installation Guide Page 18